Updated: January 2007
Replaced the old "CAT BACK FLO-PRO DUAL EXHAUST" with a Magnaflow Muffler and cat.
Job started with just the muffler and tailpipe. Rest of the 3" piping is coming soon.
1st batch of photos are the muffler back install.
|
Below: Thanks to Phil of Phil's Muffler Shop of Fort Worth, TX
3318 North Main St. / 817 740-1339
Below: 24" long muffler waiting to be welded in place.
Below: Here's box end with the part so avoid e-mails asking what part # is used.
Below: The wait is over. Muffler being welded to the old pipe.
Below: 3" tail pipe being bent to fit.
Below: Tailpipe installed and now getting cut to fit on the tip.
Below: Chrome tip being welded in place.
Below: Chrome tip in place.
Updated: February 2007
Replaced the old cat with a Magnaflow cat.
Also replaced the old glass pack with a 3" glass pack
|
Below: "Y" section of the old Y-pipe and stock cat.
Below: The new Magnaflow Cat and 3" glass pack.
Below: Out;et side of the new cat.
Below: Looking into the new glass pack.
Below: Welding the pipes to the new cat.
Below: The pipes leading up to the manifolds needed to be unbolted to allow
room to weld the top of the pipes.
Below: A fitting for the rear O2 sensor being welded in to the pipe.
Below: Muffler in place.
Below: Muffler and Glass Pack
Below: Magnaflow Cat in place.
|
Below: Installed. Put
a layer of the reflective tape on the frame as well as the tranny
pan. Frame was getting hot.
With the tape in place the frame stays cool to the touch. This
shot and the next one were taken while the system was checked
for leaks. Found a pin hole leak on a weld by the rear of the
muffler and one in a factory weld on the cat. |
|
Below: Cool shot while
one of the pin holes were fixed. |
Modifications
|
