AMSOIL BMK-13
The AMSOIL By-Pass Oil
Filter provides the best possible filtration protection against
wear, oil degradation, rust and corrosion. Working in conjunction
with the engine's full-flow oil filter, the AMSOIL By-Pass Filter
operates by filtering oil on a partial-flow basis. It draws approximately
ten percent of the oil at any one time and traps the extremely
small, wear-causing contaminants and water that full-flow filters
can't remove. The AMSOIL By-Pass Filter typically filters all
the oil in the system several times an hour, so the engine continuously
receives analytically clean oil.
|
|
Reduces
Wear
Approximately 60 percent of all
engine wear is caused by dirt particles in the 5 to 20 micron
range. These particles can get inside the precision clearances
between engine components and cause severe damage. While full-flow
oil filters generally stop contaminants no smaller than 25 to
40 microns, the AMSOIL By-Pass Filter effectively stops particles
smaller than one micron in size, substantially reducing engine
wear.
|
Prevents
Oil Degradation, Rust and Corrosion
Water enters motor oil
as a combustion by-product or as a condensate. Water contamination
of the motor oil can cause extreme engine damage. Water causes
metal surface rust and corrosion, which increases friction and
wear and deteriorates the close-fitting tolerances between engine
components. In addition, water reacts with other oil contaminants
to form corrosive acids, which also damage metal components.
The AMSOIL By-Pass Filter removes water, reducing the risk of
oil degradation, engine rust and corrosion.
|
Extends
Oil Drain Intervals
Because the AMSOIL By-Pass
Oil Filter removes water and particles smaller than one micron,
it significantly increases the time oil can safely be left in
the engine. In fact , engines using AMSOIL Synthetic Motor Oil
and an AMSOIL By-Pass Oil Filter routinely show much lower rates
of engine wear - even when the oil is used for significantly
longer drain intervals - than engines using conventional products
and conventional oil drain intervals. That saves motorists time
and money and helps protect the environment by creating substantially
less used oil.
|
Dual
Remote Filter System
The AMSOIL Dual Remote
Oil Filtration System converts an engine's full-flow oil filter
system into a full-flow/by-pass oil filtration system by attaching
an AMSOIL Full-Flow Oil Filter and AMSOIL Spin-On By-Pass Oil
Filter onto a remote mount. The Dual Remote System provides superior
filtration efficiency, increased oil capacity and improved oil
filtration accessibility.
|
Above
and below: Oil filter is replace with the Spin-on filter adapter
Below:
The 13/32 inch I.D. oil
hose
was easy to route from the filter adapter to the onto a remote
filter mount. I did cover the hose with 3/4 inch split wire loom
for extra protection.
Below:
With the front bumper removed, installing the Dual remote mount
assembly with Oil sampling petcock valve. Only 4 holes were drilled
for the top mounting bracket.
Below:
Only 4 holes were drilled for the top mounting bracket.
| Below: NOTICE: Updated photo shows 2 additional
bolts securing the back half of the oil filter mount. As stated
in the installation instructions the filter mount needs to be
secured by all 4 mounting holes. The 2 new 1/4 inch bolts are bolted to the body section above the oil filter mount. This was done shortly after
the original installation. Just took me a while to find the photos
and up date this page. |
Click here for Dual Remote Filtration System Mounting Kit Installation and Servicing Instructions
Click Here for AMSOIL Products
|
For complete information on the
AMSOIL BMK-13 By-Pass Oil Filter Mounting Kit, click on the above
link and click the " Oil Filters & By-Pass" section. |
|
|
